These instruction apply to the following models: C850
The C850 is an electromechanical operator designed for moving sliding gates.
The non-reversing system is guaranteed by an electric brake that prevents manual movement of the sliding leaf when the motor is stopped, and therefore does not require an electric lock.
A handy manual release makes it possible to manoeuvre the gate in case of black-out or operator inefficiency
C850是一款專為移動滑動門而設計的機電操作器。
非反轉系統由電動制動器保證，防止電機停止時滑動葉片的手動移動，因此不需要電鎖。
非換向系統由電動制動器保證，當電機停止時，可防止滑動葉片的手動運動，因此不需要電動鎖。
便捷的手動釋放裝置可以在停電或操作效率低的情況下操縱門。
FAAC門電機C850規格大小
Installing the automated system
Preliminary checks
For the safety and correct operation of the automated system, ensure that the following conditions are met:
• The gate structure must be designed to be automated. In particular, the diameter of the wheels must conform to the weight of the gate being automated, there must be a guide on top and mechanical limit switches sized to suit the weight and speed of the movable leaf, to avoid derailment of the gate;
• Initially, leave at least 10 cm of clearance between the movable leaf stopping points (open and close) and the mechanical stops of the gate. The final adjustment is made once the inverter programming precedure is completed. Minimum distance 3 cm.
• The gate sliding rail must be linear and horizontal.
• Manual movement of the gate must be smooth along the entire stroke.
• The characteristics of the ground must guarantee sufficient solidity of the foundation plinth.
• No tubes or electrical cables should be present in the plinth digging area.
• If the gear motor is exposed to vehicle transite, provide for adequate protection against accidental impact, when possible.
• Ensure that there is an efficient earth plate for connecting the gearmotor.
Should various elements not need the above-mentioned conditions, adjust them so they do.
在線客服